Best Guide Hyundai Tucson Maintenance Checklist

Best Guide Hyundai Tucson Maintenance Checklist

EngineOil and Filter

The engine oil and filter should be changed at the intervals specified in the maintenance schedule. If the car is beingdriven in severe conditions, more frequent oil and filter changes are required.

FuelFilter

A clogged filter can limit the speed at which the vehicle may be driven, damage the emission system and cause hard starting. If an excessive amount of foreign matter accumulates in the fuel tank, the filter may require replacement more frequently.

After installing a new filter, run the engine for several minutes, and check for leaks at the connections. Fuel filters should be installed by trained technicians.

FuelLines, Fuel Hosesand Connections

Check the fuel lines, fuel hoses and connections for leakage and damage. Have a trained technician replace any damaged or leaking parts immediately.

Vacuum,Crankcase Ventilation Hoses

Inspect the surface of hoses for evidence of heat and/or mechanical damage. Hard and brittle rubber, cracking, tears, cuts, abrasions, and excessive swelling indicatedeterioration. Particular attention should be paid to examine those hose surfaces nearest to high heat sources, such as the exhaust manifold. Inspect the hose routing to assure that the hoses do not come in contact with any heat source, sharp edges or moving component which mightcause heat damage or mechanical wear. Inspect all hose connections, such asclamps and couplings, to make sure they are secure, and that noleaks are present. Hoses should be replaced immediately if there is any evidence of deterioration or damage.

VaporHose and Fuel FillerCap

The vapor hose and fuel filler cap should be inspected at those intervals specified in the maintenance schedule. Make sure that a new vapor hose or fuel filler cap is correctly replaced.

AirCleaner Filter

A Genuine Hyundai air cleaner filter is recommended when filter is replaced.

SparkPlugs

Make sure to install new spark plugs of the correct heat range.

DriveBelts

Inspect all drive belts for evidence of cuts, cracks, excessive wear or oil and replace if necessary. Drive belts should be checked periodically for proper tension and adjusted as necessary.

EngineCoolant

The coolant should be changed at the intervals specified in the maintenance schedule.

TimingBelt

Inspect all parts related to the timing belt for damage and deformation. Replace any damaged parts immediately.

ManualTransaxle Oil

Inspect the manual transaxle oil according to the maintenance schedule.

NOTE:

If the oil level is low, check for possible leaks before adding oil. Do not overfill.

Automatic Transaxle Fluid and Filter

The fluid level should be in the "HOT" range of the dipstick, after the engine and transaxle are at normaloperating temperature. Check the automatic transaxle fluid level with the engine run running and the transaxle in neutral, with the parking brake properly applied. Use HYUNDAI ATF SP-II, DIAMOND ATF SP-II or AUTRANMMSP-II when adding or changing fluid.

BrakeFluid

Check brake fluid level in the brake fluid reservoir. The level should be between "MIN" and "MAX" marks on the side of the reservoir. Use only hydraulic brake fluid conforming to DOT 3.

BrakeHoses and Lines

Visually check for proper installation, chafing, cracks, deterioration and any leakage. Replace any deteriorated or damaged parts immediately.

RearBrake Drums/Linings, ParkingBrake

Check the rear brake drums and linings for scoring, burning, leaking fluid, broken parts, and excessive wear. Inspect the parking brake systeM  including the parking brake lever and cables.

BrakePads, Calipers andRotors

Check the pads for excessive wear, discs for run out and wear, and calipers for fluid leakage.

ExhaustPipe and Muffler

Visually inspect the exhaust pipes, muffler and hangers for cracks, deterioration, or damage. Start the engine and listen carefully for any exhaust gas leakage. Tighten connections or replace parts as necessary.

Suspension Mounting Bolts

Check the suspension connections for looseness or damage. Retighten to the specified torque.

SteeringGear Box, Linkage& Boots/Lower armBall Joint

With the vehicle stopped and engine off, check for excessive free-play in the steering wheel. Check the linkage for bendsor damage. Check the dust boots and ball joints for deterioration, cracks, or damage. Replace any damaged parts.

PowerSteering Pump, Beltand Hoses

Check the power steering pump and hoses for leakage and damage. Replace any damaged or leaking parts immediately. Inspect the power steering belt for evidence of cuts, cracks, excessive wear, oiliness and proper tension. Replace or adjust it if necessary.

Driveshafts and Boots

Check the drive shafts, boots and clamps for cracks, deterioration, or damage. Replace any damaged parts and, if necessary, repack the grease.

AirConditioning Refrigerant

Check the air conditioning lines and connections for leakage and damage.

The Supplemental Restraint System (SRS) should be inspected every ten years.