Monday, September 4, 2017

Best Guide Chevrolet Volt TPMS Reset Guide


Best Guide Chevrolet Volt TPMS Reset Guide
Best Guide Chevrolet Volt TPMS Reset Guide
     WITH STANDARD IGNITION:1. Set parking brake.
2. Turn ignition to ON/RUN (engine off).
3. Use the MENU button to select the Vehicle Information menu in the Driver Information Center (DIC).
4. Use thumbwheel to scroll to the Tire Pressure menu item screen.
5. Press the SET/CLR button to begin sensor matching process. A message requesting acceptance of the process should display.
6. Press the SET/CLR button again to confirm selection.
7. Starting with LF tire, increase/decrease tire pressure until horn sounds, or use TPMS relearn tool to activate each sensor.
8. After horn sounds proceed as in step 5 for the next 3 sensors in the following order:  RF, RR, LR. After completing LR tire, horn will sound twice."                                                                                                                               
"9. Turn ignition to OFF position to exit vehicle learn mode. Adjust all tires to pressure listed on tire placard.

WITH PUSH-BUTTON START:


1. Press and hold the push button start until the vehicle is in accessory mode.  Note:  on Cadillac
2. Press the MENU button located on the turn signal lever until ""VEHICLE INFORMATION MENU"" is displayed.
3. Once you are in the VEHICLE INFORMATION MENU, use the ^ v on the turn signal lever until
the DIC displays the vehicle's tire inflation pressures and positions.
4. Press and hold the button located on the end of the turn signal lever until ""Are you sure that you want to relearn? YES or NO"" is displayed.
5. Use the ^ v on the turn signal lever to highlight YES.  Once YES is highlighted, press the button located on the end of the turn signal lever. The horn will chirp, ""Tire Learning Active"" will be
displayed on the DIC, and the left front turn signal will be illuminated.
6. Beginning with the left front tire, use a TPMS activation tool to activate the left front sensor. Once the sensor has been activated, the horn will chirp and the right front turn signal will be illuminated. Repeat procedure in following order, right front sensor, right rear sensor, and finally the left rear sensor.  Once the left rear sensor has been activated, the horn will chirp twice. You
can then turn the vehicle off to exit ""learn mode."""                                                                                               
                               
otobasics Web Developer

No comments:

Post a Comment