BUICK LeSabre TPMS reset

BUICK LeSabre TIRE PRESSURE MONITORING RESET

YEAR MODEL: 2001

To reset (calibrate) the system with a Driver Information Center (DIC):

1. Turn the ignition switch to ON.

2. Using the MODE and SELECT buttons, change the DTC to display TIRE PRESSURE.

3. Press and hold the RESET button for about five seconds.

4. The display should change to read TIRE PRESSURE RESET. If TIRE PRESSURE RESET does not appear on the display after about five seconds, see your dealer for service.

5. When you release the button after seeing the TIRE PRES SURE RESET message, the display will change to read TIRE PRESSURE NORMAL.

To reset (calibrate) the system with a systems monitor:

1. Turn the ignition switch to ON.

2. Press and hold the TIRE PRESS RESET button for about five seconds.

3. The TIRE PRESS light on the systems monitor should begin to flash. If the TIRE PRESS light does not begin to flash after about five seconds, see your dealer for service.

4. Release the TIRE PRESS RESET button and the system should reset The TIRE PRESS light will go out.

The system completes the calibration process during driving. Calibration time can take 45 to 90 minutes, depending on your driving habits. After the system has been calibrated, the system will alert the driver that a tire is low, up to a maximum speed of 65 mph (105 km/h).

BUICK LeSabre TIRE PRESSURE MONITORING RESET

The post BUICK LeSabre TPMS reset appeared first on Seraphicguy.com.